[ Contents] [ Prev] [ Next] [ Report an Error]

Removing the Craft Interface

The craft interface is located on the front of the chassis above the FPC card cage. The craft interface weighs approximately 2 lb (0.9 kg). To remove the craft interface, follow this procedure (see Figure 6):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  2. Completely loosen the screws at the four corners of the craft interface.
  3. Insert the blade of a flat-blade screwdriver into the slot on one side of the craft interface, then gently pry that side out from the chassis.
  4. Repeat Step 3 for the other side of the craft interface.
  5. Grasp the craft interface by the top and bottom edges and carefully pull it straight out of the chassis.

Figure 6: Removing the Craft Interface

Image g002429.gif


[ Contents] [ Prev] [ Next] [ Report an Error]