[ Contents] [ Prev] [ Next] [ Report an Error]

Installing the Craft Interface

To install the craft interface, follow this procedure (see Figure 7):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  2. Grasping the craft interface by the top and bottom edges, press it into place.
  3. Tighten the screws at the corners of the craft interface.

    Note: When you install the craft interface in an operating routing node, allow several minutes for the LEDs on the craft interface to reflect the current state of the routing node.

After you install the replacement craft interface, immediately reinstall the upper front fan tray.

Figure 7: Installing a Replacement Craft Interface

Image g001528.gif


[ Contents] [ Prev] [ Next] [ Report an Error]