[ Contents] [ Prev] [ Next] [ Report an Error]

MultiServices PICs (M320 Router)

Figure 19: MultiServices 100 PIC

Image g002375.gif

Figure 20: MultiServices 400 PIC

Image g002376.gif

Figure 21: MultiServices 500 PIC

Image g003905.gif

Software release

  • MultiServices 100: JUNOS 8.1 and later (Type 1)
  • MultiServices 400: JUNOS 8.1R2 and later (Type 2)
  • MultiServices 500: JUNOS 8.3 and later (Type 3)

Description

  • Supports tunnel services. This feature is included with the PIC and does not require an individual license.
  • Individual licenses must be purchased for additional services.
  • Power requirement:
    • Type 1: 0.52 A @ 48 V (25 W)
    • Type 2: 0.69 A @ 48 V (33 W)
    • Type 3: 0.83 A @ 48 V (40 W)

Hardware features

  • Active monitoring on:
    • Type 1: up to 1.6 million flows
    • Type 2: up to 3.2 million flows
    • Type 3: up to 3.2 million flows

Software features

  • Support for up to 2000 service sets
  • Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces

Depending on your JUNOS release and individual licenses, software features for this PIC can include the features listed in Table 24. For more information about the software features available for services PICs, see the JUNOS Services Interfaces Configuration Guide.

LEDs

Status LED, one tricolor:

  • Off—PIC is offline and it is safe to remove it from the chassis.
  • Green—PIC is operating normally.
  • Amber—PIC is initializing.
  • Red—PIC has an error or failure and no further harm can be done by removing it from the chassis.

Application LED, one bicolor:

  • Off—Service is not running.
  • Green—Service is running under acceptable load.
  • Amber—Service is overloaded.

Table 24: MultiServices PICs Software Features Supported on the M320 Router

Software Feature

MultiServices 100

MultiServices 400

MultiServices 500

GRE Key

GRE dont-fragment

Stateful firewall with packet inspection: detects SYN attacks, ICMP and UDP floods, and ping-of-death attacks

8.1

8.1R2

8.3

Network Address Translation (NAT) for IP addresses

8.1

8.1R2

8.3

Port Address Translation (PAT) for port numbers

8.1

8.1R2

8.3

IP Security (IPSec) encryption

8.1

8.1R2

8.5

Flow monitoring exports cflowd version 5 and version 8 records

8.1

8.1R2

8.3

Flow monitoring exports flow monitoring version 9 records, based on RFC 3954

8.3

8.3

8.5

Passive flow monitoring

8.4

Passive flow collection

8.5

Flow-tap

8.2

8.2

8.5

Dynamic flow capture

8.4

RPM

8.2

8.2

8.5

Link Services

8.1

8.1R2

8.5

Tunnel services:

  • IP-IP unicast tunneling
  • GRE unicast tunneling—Supports GRE fragmentation
  • Protocol Independent Multicast (PIM) sparse mode unicast tunneling

8.1

8.1R2

8.5

Virtual tunnel interface for Layer 3 VPNs

8.1

8.1R2

8.5

Layer 2 Tunneling Protocol (L2TP)

Voice services:

  • Compressed Real-Time Transport Protocol (CRTP)

8.1

8.1R2

8.5

Encapsulations:

  • Multilink Frame Relay (MLFR)
  • Multilink Point-to-Point Protocol (MLPP)

8.1

8.1R2

8.5


[ Contents] [ Prev] [ Next] [ Report an Error]