Channelized SONET/SDH OC12/STM4 Enhanced IQ (IQE) PIC with SFP

Software release

JUNOS 9.3 and later (Type 1)

Description	One OC12/STM4 port SONET or SDH is configurable on a per-port granularity Channelization: OC3, DS3, DS1, DS0 SONET channelization: 1 OC12 channel 4 OC3 channels 12 DS3 channels 336 DS1 channels 1011 DS0 channels SDH channelization: 1 STM4 channel 4 STM1 channels 12 E3 channels 252 E1 channels 1011 DS0 channels Power requirement: 0.64 A @ 48 V (30.7 W)
Hardware features	Port is numbered 0.
Software features	Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection (RED), weighted random early detection (WRED) Enhanced fine-grained queuing per logical interface. See the JUNOS Class of Service Configuration Guide for more information about class of service features. Subrate and scrambling: Digital Link/Quick Eagle Kentrox Larscom ADTRAN Verilink Packet buffering, Layer 2 parsing M13/C-bit parity encoding DS3 far-end alarm and control (FEAC) channel support Local line, remote line, and remote payload loopback testing Simple Network Management Protocol (SNMP): OC3 MIB, DS3 MIB, T1 MIB Dynamic, arbitrary channel configuration Full bit error rate test (BERT) Encapsulations: Circuit cross-connect (CCC) Translational cross-connect (TCC) Extended Frame Relay for CCC and TCC Flexible Frame Relay Frame Relay Frame Relay for CCC Frame Relay for TCC Frame Relay port CCC High-Level Data Link Control (HDLC) HDLC framing for CCC HDLC framing for TCC MPLS CCC MPLS TCC Multilink Frame Relay (MLFR) UNI NNI (MFR FRF.16) Point-to-Point Protocol (PPP) PPP for CCC PPP for TCC
Cables and connectors	Duplex SC/PC connector (Rx and Tx); single-mode fiber Optical interface support—See Table 11
LEDs	One tricolor per port: Off—Not enabled Green—Online with no alarms or failures Amber—Online with alarms for remote failures Red—Active with a local alarm; router has detected a failure
Alarms, errors, and events	SONET alarms: Alarm indication signal—line (AIS-L) Alarm indication signal—path (AIS-P) Bit error rate—signal degrade (BERR-SD) Bit error rate—signal fail (BERR-SF) Loss of clock (LOC) Loss of frame (LOF) Loss of light (LOL) Loss of pointer (LOP) Loss of signal (LOS) Payload label mismatch (PLM-P) Remote defect indication—line (RDI-L) Remote defect indication—path (RDI-P) Remote error indication (REI) Payload unequipped (unequipped STS at path level) (UNEQ-P) Virtual container—alarm indication signal (VAIS) Virtual container—loss of clock (VLOC) Virtual container—loss of pointer (VLOP) Virtual container—mismatch (VMIS) Virtual container—remote defect indication (VRD1) Virtual container—unequipped (VUNEQ)
	SDH alarms: Administrative unit alarm indication signal (AU-AIS) Bit error rate—signal degrade (BERR-SD) Bit error rate—signal fail (BERR-SF) Bit interleaved parity (BIP) error B1, B2, B3 Higher order path—alarm indication signal (HP-AIS) Higher order path—far-end receiver error (HP-FERF) Higher order path—payload label mismatch (HP-PLM) Higher order path—loss of pointer (HP-LOP) Higher order path—remote defect indication (HP-RDI) Higher order path—unequipped (HP-UNEQ) Loss of clock (LOC) Loss of frame (LOF) Loss of light (LOL) Loss of signal (LOS) Multiplex section—alarm indication signal (MS-AIS) Multiplex section—far-end receive error (MS-FERF) Multiplex section—remote defect indication (MS-RDI) Multiplex section—remote error indication (MS-REI) Phase lock loop (PLL) Remote error indication (REI) Severely errored frame (SEF) Tributary unit—alarm indication signal (TU-AIS) Tributary unit—loss of clock (TU-LOC) Tributary unit—loss of pointer (TU-LOP) Tributary unit—mismatch (TU-MIS) Tributary unit—remote defect indication (TU-RD1) Tributary unit—unequipped (TU-UNEQ)
	DS1 alarms: Alarm indication signal (AIS) Loss of frame (LOF) Remote alarm indication signal (RAIS) DS1 error detection: Bursty errored seconds (BES) CRC errors Errored seconds (ES) Line errored seconds (LES) Loss of framing seconds (LOFS) Loss of signal seconds (LOS) Severely errored seconds (SES) Severely errored framing seconds (SEFS) Unavailable seconds (UAS) DS3 alarms: Alarm indication signal (AIS) Loss of frame (LOF) Loss of signal (LOS) Phase lock loop (PLL) DS3 error detection: C-bit code violations (CCV) C-bit errored seconds (CES) C-bit severely errored framing seconds (CEFS) CRC errors Excessive zeros (EXZ) Far-end block error (FEBE) Far-end receive failure (FERF) Line errored seconds (LES) Parity bit (P-bit) code violations (PCV) Parity bit (P-bit) errored seconds (PES) Parity bit (P-bit) severely errored framing seconds (PSES) Severely errored framing seconds (SEFS) Unavailable seconds (UAS)
Instrumentation (counters)	Layer 2 per-queue and per-channel packet and byte counters

Table 11: Optical Interface Support for Channelized SONET/SDH OC12/STM4 IQE PICs

Parameter	Short Reach (SR-1)	Intermediate Reach (IR-1)	Long Reach (LR-1)
Transceiver model number	SFP-1OC12-SR	SFP-1OC12-IR	SFP-1OC12-LR
Optical interface	Single-mode	Single-mode	Single-mode
Transceiver type	SFP	SFP	SFP
Maximum distance	SMF cable: 1.24 miles/2 km	SMF cable: 9.3 miles/15 km	SMF cable: 24.85 miles/40 km
Standard	Telcordia GR-253	Telcordia GR-253	Telcordia GR-253
Transmitter wavelength	1261 through 1360 nm	1274 through 1356 nm	1280 through 1335 nm
Average launch power	–15 through –8 dBm	–15 through –8 dBm	–3 through +2 dBm
Receiver saturation	–8 dBm	–8 dBm	–8 dBm
Receiver sensitivity	–23 dBm	–28 dBm	–28 dBm