[ Contents] [ Prev] [ Next] [ Report an Error]

10-Gigabit Ethernet PIC with XENPAK (M320 Router)

Image g001885.gif

Software release

  • 10GBASE-LR and 10GBASE-ER transceivers: JUNOS 6.2 and later (Type 3)
  • 10GBASE-SR and 10GBASE-ZR transceivers: JUNOS 7.1 and later (Type 3)

Description

  • One 10-Gigabit Ethernet port
  • Power requirement: 0.55 A @ 48 V (26.6 W)
  • Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network

Hardware features

  • High-performance throughput at speeds up to 10 Gbps
  • Full-duplex mode
  • Maximum transmission units (MTUs) up to 9192 bytes
  • 64 source MAC address filters
  • 960 destination MAC filters

Software features

  • Virtual Router Redundancy Protocol (VRRP) support
  • 802.1q virtual LANs (VLANs) support
  • 802.3ae link aggregation support
  • RMON EtherStats
  • Optical diagnostics and related alarms :
    • Transceiver temperature
    • Laser bias current
    • Laser output power
    • Receive optical power

Cables and connectors

  • Duplex SC/PC connector (RX and TX)
  • Optical interface support—See Table 22

LEDs

Status LED, one bicolor:

  • Off—PIC not enabled
  • Green—PIC is operating normally
  • Red—PIC has an error or failure

Port LEDs, one pair:

  • Link—If green, the port is online; if there is no light, the port is down
  • RX—If flashing green, the port is receiving data; if there is no light, the port might be on but is not receiving data

[ Contents] [ Prev] [ Next] [ Report an Error]