[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Replacing the Cable Management System

Removing the Cable Management System

The cable management system is located on both sides of the card cage. The cable management system weighs approximately 0.3 lb (0.14 kg).

To remove the cable management system (see Figure 71):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  2. Loosen the captive screws on either side of the chassis.
  3. Remove the cable manager.

Figure 71: Removing or Installing the Cable Management System

Image g030240.gif

Installing the Cable Management System

To install the cable management system (see Figure 71):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  2. Position the cable management system on the front sides of the chassis.
  3. Insert the tabs into the slots.
  4. Tighten the captive screws completely.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]