Removing the Mounting Brackets for Center-Mounting the Device
Two removable mounting brackets are attached to the mounting
holes closest to the front of the chassis. You can move the pair of
brackets to another position on the side of the chassis for center-mounting
To move the mounting brackets from the front of the chassis
toward the center of the chassis, follow this procedure for each bracket:
Remove the three screws at the top and center
of the bracket.
Pull the top of the the bracket slightly away
from the chassis. The bottom of the bracket contains a tab that inserts
into a slot in the chassis.
Pull the bracket away from the chassis so that
the tab is removed from the chassis slot.
Insert the bracket tab into the slot in the bottom
center of the chassis.
Align the bracket with the two mounting holes located
toward the top center of the chassis.
There is no mounting hole in the center of the chassis that
corresponds to the hole in the center of the bracket.
Insert the two screws at the top of the bracket
and tighten each partially.
Two screws are needed for mounting the bracket on the center
of the chassis. You do not need the third screw.