[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Reinstalling SCBs

To reinstall an SCB, follow this procedure for each SCB (see Figure 78):

Caution: Before removing or replacing an SCB, ensure that the ejector handles are stored vertically and pressed toward the center of the SCB.

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  2. Carefully align the sides of the SCB with the guides inside the chassis.
  3. Slide the SCB into the chassis, carefully ensuring that it is correctly aligned.
  4. Grasp both ejector handles and rotate them simultaneously clockwise until the SCB is fully seated.
  5. Place the ejector handles in their proper position, horizontally and toward the center of the board.

Figure 78: Installing an SCB

Image g030248.gif


[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]