[
Contents]
[
Prev]
[
Next]
[
Report an Error]
Connect the Grounding Cable
- Attach
an electrostatic discharge (ESD) grounding strap to your bare wrist
and connect the strap to an approved site ESD grounding point. See
the instructions for your site.
- Connect the grounding cable to a proper earth ground.
- Verify that a licensed electrician has attached
the cable lug provided with the services gateway to the grounding cable.
- Attach an electrostatic discharge (ESD) grounding strap to your bare
wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see the SRX 5600 Services Gateway Hardware Guide.
- Place the grounding cable lug over the grounding
point. The grounding point is sized for UNC 1/4-20 nuts.
- Secure the grounding cable lug to the grounding
point, first with the washers, then with the screws.
- Verify that the grounding cabling is correct, that
the grounding cable does not touch or block access to device components,
and that it does not drape where people could trip on it.
[
Contents]
[
Prev]
[
Next]
[
Report an Error]