[ Contents] [ Prev] [ Next] [ Report an Error]

Cooling System

The cooling system consists of the following components:

The cooling system components work together to keep all services gateway components within the acceptable temperature range (see Figure 1, Figure 2, and Figure 3 ). The device has one fan tray and one air filter that install vertically in the rear of the device. The fan tray contains three fans.

The air intake to cool the chassis is located on the side of the chassis next to the air filter. Air is pulled through the chassis toward the fan tray, where it is exhausted out the side of the system. The air intake to cool the power supplies is located in the front of the device above the craft interface. The exhaust for the power supplies is located on the rear bulkhead power supplies.

Figure 1: Airflow Through the Chassis

Image g004211.gif

The host subsystem monitors the temperature of the services gateway components. When the device is operating normally, the fans function at lower than full speed. If a fan fails or the ambient temperature rises above a threshold, the speed of the remaining fans is automatically adjusted to keep the temperature within the acceptable range. If the ambient maximum temperature specification is exceeded and the system cannot be adequately cooled, the Routing Engine shuts down the system by disabling output power from each power supply.

Figure 2: Fan Tray

Image g004212.gif

Figure 3: Air Filter

Image g004213.gif


[ Contents] [ Prev] [ Next] [ Report an Error]