[Contents] [Prev] [Next] [Index] [Report an Error]

Monitoring Temperatures of Modules

You can view the temperature of each module by issuing the show environment all and show environment table commands. In addition, the system generates detailed log messages if the temperature of a module is outside normal operating limits.

If the temperature of any module exceeds the upper temperature limit, the system immediately goes into thermal protection mode. Once the system has entered thermal protection mode, you must resolve the cause of the high temperature.

Table 10-6 Troubleshooting high-temperature conditions
Cause of High Operating Temperature
Air vents to system are blocked
Space around system does not meet specifications (see Chapter 11, System Specifications).
Increase space around system.
Ambient temperature exceeds specifications
Ambient temperature exceeds specifications (see Chapter 11, System Specifications).
Provide extra cooling or heating in the room where the system is located.
Cooling fan failure
  • FAN OK LED on SRP module is not illuminated.
  • FAN FAIL LED on SRP module is illuminated.
Module failure
FAIL LED on module is illuminated.
Replace module (see Chapter 5, Installing Modules).

When you have resolved the cause of the high temperature, you must power cycle the system to reset the modules.

[Contents] [Prev] [Next] [Index] [Report an Error]