[ Contents] [ Prev] [ Next] [ Report an Error]

Switching Host Module Mastership on an M40e Router

On an M40e router with two host modules installed, determine whether the component you are removing belongs to the master host module. If it does, switch mastership to the other host module before removing the component. To check and switch host module mastership:

  1. Use one of the following two methods to determine which host module is functioning as master:
  2. If you are removing a component that belongs to the master host module, issue the following CLI command to switch mastership to the standby host module:
    user@host> request chassis routing-engine master switch

    If the Routing Engines are configured for graceful switchover and are running a JUNOS release that supports graceful switchover, the standby Routing Engine immediately assumes Routing Engine functions and there is no interruption to packet forwarding. Otherwise, packet forwarding halts while the standby Routing Engine becomes the master and the Packet Forwarding Engine components reset and connect to the new master Routing Engine. For information about configuring graceful switchover, see the section about Routing Engine redundancy in the JUNOS System Basics Configuration Guide.

    We recommend you run JUNOS Release 7.0 or later on the M10i router to support graceful switchover.

    Note: Router performance might change if the standby Routing Engine's configuration differs from the former master's configuration. For the most predictable performance, configure the two Routing Engines identically, except for parameters unique to a Routing Engine, such as the hostname defined at the [edit system] hierarchy level and the management interface (fxp0 or equivalent) defined at the [edit interfaces] hierarchy level.

    To configure Routing Engine-specific parameters and still use the same configuration on both Routing Engines, include the appropriate configuration statements under the re0 and re1 statements at the [edit groups] hierarchy level and use the apply-groups statement. For instructions, see the JUNOS System Basics Configuration Guide.

[ Contents] [ Prev] [ Next] [ Report an Error]