Removing a Routing Engine from an M20 Router

To remove a Routing Engine from an M20 router, follow this procedure:

1. Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the Routing Engine.
2. Attach an ESD strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
3. If two Routing Engines are installed, check whether the Routing Engine you are removing is the master. If so, switch mastership to the standby Routing Engine. For instructions, see Switching Routing Engine Mastership on an M20 Router.
4. Use one of the following methods to request a system halt on the M20 router:
   • Press the square RE0 or RE1 button to the right of the Routing Engine. This shuts down the Routing Engine cleanly, so that its state information is preserved.
   • On the console or other management device connected to the Routing Engine, enter CLI operational mode and issue the following command. The command shuts down the Routing Engine cleanly, so that its state information is preserved:

     user@host> request system halt

     Wait to continue until a message appears on the console confirming that the operating system has halted.

5. If applicable, loosen the screws on the extractor clips at either end of the Routing Engine faceplate, using a Phillips screwdriver.
6. Flip the ends of the extractor clips outward (see Figure 5).
7. Grasp the extractor clips and slide the unit about halfway out of the chassis.     

   Caution: Be careful to slide the Routing Engine straight out of the chassis. Damage can result if it gets lodged because of uneven movement.

8. Place one hand under the Routing Engine to support it, slide it completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag prepared in Step 1.

   Figure 5: Removing a Routing Engine from an M20 Router