Removing and Installing an AC Power Supply Module

Note: If your system is powered on, see the SRC PE CLI User Guide, Chapter 5, Using the SRC CLI Operational Commands to Monitor the SRC Software for commands to run before performing these steps.

To remove an AC power supply module:

  1. Unplug the AC power cord.
  2. Slide the locking tab (ejector button) to the left to release the module. See Figure 14 and Figure 15.
  3. Hold the tab to the left, and using the handle, slowly pull the power supply module out.

To install an AC power supply module:

  1. Hold the locking tab (ejector button) to the left, and slowly slide the module into the chassis until it clicks into place.
  2. Insert the power cord into the AC power IEC receptacle.

Figure 14: C2000 AC Power Supply

Image g016121.gif

Figure 15: C4000 AC Power Supply

Image g016120.gif