[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Removing and Installing a Power Supply Module

Note: If your system is powered on, see the SRC–PE CLI User Guide, Chapter 5, Using CLI Operational Commands to Monitor the SRC Software for commands to run before performing these steps.

To remove a power supply module:

  1. Unplug the power cord.
  2. Slide the locking tab (ejector button) to the left to release the module. See Figure 11 and Figure 12.
  3. Hold the tab to the left, and using the handle, slowly pull the power supply module out.

To install a power supply module:

  1. Hold the locking tab (ejector button) to the left, and slowly slide the module into the chassis until it clicks into place.
  2. Insert the power cord into the AC power IEC receptacle.

Figure 11: C2000 Power Supply

Image g016121.gif

Figure 12: C4000 Power Supply

Image g016120.gif


[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]