Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing a Client Node from an Active SSR Cluster

    Note: This procedure makes the following assumption:

    Caution: This procedure requires you to restart the component database on all management servers in the cluster, which is a disruptive process. This procedure should be performed only during a maintenance window. Review this procedure in full before proceeding.

    To remove a client node from an active cluster:

    1. Place the database into maintenance mode.

      See Placing the SSR Database into Maintenance Mode (SRC CLI).

    2. Disable the component database on all management servers in the cluster (one by one).

      See Disabling the SSR Database (SRC CLI).

    3. Disable the component database on the client node you removed from the cluster.

      See Disabling the SSR Database (SRC CLI).

    4. Enable the component database on all management servers in the cluster (one by one).

      See Enabling the SSR Database (SRC CLI).

    5. Restart the SSR component database on all client nodes.

      See Enabling the SSR Database (SRC CLI).

    6. Restart all SSR client components.

      See Enabling SRC Components.

    7. Verify the cluster configuration changes by viewing the status of the database.

      See Viewing the Status of the SSR Cluster (SRC CLI).

    8. Place the database into production mode.

      See Placing the SSR Database into Production Mode (SRC CLI).

    Published: 2014-06-19