Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Enabling the Juniper Networks Database to Run in Community Mode

(SRC CLI)

 

If you are adding a Juniper Networks database to an existing community, see Adding a Juniper Networks Database to an Established Community (SRC CLI).

Use the following configuration statements to enable the Juniper Networks database on a C Series Controller in community mode:

To enable the Juniper Networks database to run in community mode:

  1. From configuration mode, access the configuration statement that configures the Juniper Networks database in community mode:

  2. Specify the role of the database as primary or secondary:

    or

  3. Configure primary neighbors. Specify each neighbor by IP address, fully qualified hostname, or a hostname that can be resolved through the domain name system:

    For example, set C1 and C2 as primary neighbors:

    user@host# set primary-neighbors C1 C2

  4. Specify the connection type of the configured primary neighbors as clear or secure:

    or

    Where:

    • clear—Sets LDAP as a data replication protocol between SRC and the LDAP nodes that are configured in the primary neighbors.

    • secure—Sets LDAPS as a data replication protocol between SRC and the LDAP nodes that are configured in the primary neighbors.

  5. Configure secondary neighbors. Specify each neighbor by IP address, fully qualified hostname, or a hostname that can be resolved through the domain name system:

    For example, set C3 and C4 as secondary neighbors:

    user@host# set secondary-neighbors C3 C4

  6. Specify the connection type of the configured secondary neighbors as clear or secure:

    or

    Where:

    • clear—Sets LDAP as a data replication protocol between SRC and the LDAP nodes that are configured in the secondary neighbors.

    • secure—Sets LDAPS as a data replication protocol between SRC and the LDAP nodes that are configured in the secondary neighbors.