Configuring the Initial SSR Cluster (SRC CLI)
Configuring your initial cluster is a multistep process that requires you to install your C Series Controllers, load the SRC software, and perform the following configuration steps.
For information about supported cluster configurations see Supported SSR Cluster Configurations.
This procedure assumes that you are configuring the cluster for the first time and as such, the SSR database is already in maintenance mode.
To configure your initial SSR cluster:
Configure the cluster ID.
Configure the cluster geometry.
Configure the role of each node in the cluster
Configure the management servers.
(Optional) Make desired changes to the default subscriber sessions table.
(Optional) If you are configuring the two-shared-data-node geometry, configure the database memory size.
(Optional) Make desired changes to the default attribute associations table.
Commit the configuration.
Enable the component database (must be done on each node in the SSR cluster.)
Create the SSR database. (There is no need to destroy the database because it does not exist at initial startup).
Enable each SSR client component.
Verify status of the cluster.
Place the cluster into production mode.