Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring the SRC 3GPP Gy Interface (SRC CLI)

 

Use the following configuration statements to configure SRC's Gy interface:

Note

SRC's Gy uses its own Diameter stack, which is configured under the [edit slot 0 gy-3gpp gy] hierarchy. It does not use the Diameter stack configured under the [edit system diameter] hierarchy; this Diameter stack is used for SAE and router communication.

To configure SRC's Gy interface:

  1. From configuration mode, access the statement that configures SRC's Gy interface.
  2. (Optional) Specify the Diameter identifier for the remote endpoint, which is the destination of the Diameter message. The Destination-Host AVP (AVP Code 293) is of the DiameterIdentity type and is present in all Diameter messages.
  3. Specify the Diameter identifier for the realm of the remote endpoint, which is the destination of the Diameter message. The Destination-Realm AVP (AVP Code 283) is of the DiameterIdentity type and is present in all Diameter messages.
  4. Specify the list of remote Diameter peers (OCSes) that connect to SRC's Gy over the Gy interface.

    Each Diameter peer you specify must be previously configured under the [edit shared network diameter peer] hierarchy.

  5. (Optional) Specify the protocol for the transport connection.
  6. (Optional) Specify the port to use for incoming connections.
  7. Specify the local address of the peer.
  8. Specify the Diameter identifier for the local endpoint that is the originator of the Diameter message.
  9. Specify the Diameter identifier for the realm of the local endpoint that is the originator of the Diameter message.
  10. (Optional) Verify your configuration.