Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Configuring Gigabit Ethernet Interfaces for IPv4 (SRC CLI)
You can configure the Gigabit Ethernet interfaces to use IPv4 or IPv6 to allow remote access to the C Series Controller. You can specify an IP address with mask or a broadcast address with mask for an interface.
Use the following configuration statements to configure Gigabit Ethernet interfaces to use IPv4 and the [edit] hierarchy level:
interfaces name unit unit-number
interfaces name unit unit-number family inet {address address ; broadcast broadcast ; }
To configure a Gigabit Ethernet interface to use IPv4:
- From configuration mode, access the configuration statement
that configures the interface.[edit]user@host# edit interfaces name unit unit-number
where unit-number is a number that you can assign for a logical interface identifier.
For example:
[edit]user@host# edit interfaces eth0 - Specify the unit, family, and IP address for the interface.[edit interfaces eth0]user@host# set unit number family inet address address
For example, to configure an interface with only an IP address:
[edit interfaces eth0]user@host# set unit 0 family inet address 192.2.0.10/24 - Verify the interface configuration.
[edit interfaces eth0] user@host# show unit 0 { family { inet { address 192.2.0.10/24; } } }
