Installing Signalware 9 on Linux
Steel-Belted Radius Carrier supports Signalware installation on a Linux platform.
This chapter contains the basic procedure recommended by Juniper Networks for a new Signalware 9 with Service Pack 6 installation on a Linux platform. The installation example provided here is for your convenience and assumes that this is a clean first-time installation of Signalware.
Steel-Belted Radius Carrier supports a 64-bit kernel. Your Red Hat Enterprise Linux 7 operating system must comply with a 64-bit kernel with x86-based architecture. To verify the Linux kernel, run the following command:
[root@sbr-wf-eng1 ~]# cat /etc/redhat-release Red Hat Enterprise Linux Server release 7.4 (Maipo) [root@sbr-wf-eng1 ~]# uname -a Linux sbr-wf-eng1 3.10.0-693.el7.x86_64 #1 SMP Thu Jul 6 19:56:57 EDT 2017 x86_64 x86_64 x86_64 GNU/Linux
You must refer to the following Signalware documentation for instructions to install and configure Signalware on a Linux platform:
Signalware Read Me First
Signalware Release Notes
Signalware SP Release 9C Service Pack 6 Linux Installation Manual
The Signalware documentation can be accessed from https://my.ulticom.com.
To troubleshoot errors that might occur during the installation and configuration process, see Troubleshooting Signalware Installation and Configuration.
The following topics are discussed in this chapter: