Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation  Back up to About Overview 
  
[+] Expand All
[-] Collapse All

Installing Signalware 9 on Linux

Steel-Belted Radius Carrier supports Signalware installation on a Linux platform.

This chapter contains the basic procedure recommended by Juniper Networks for a new Signalware 9 with Service Pack 6 installation on a Linux platform. The installation example provided here is for your convenience and assumes that this is a clean first-time installation of Signalware.

Steel-Belted Radius Carrier supports a 64-bit kernel. Your Red Hat Enterprise Linux 6 operating system must comply with a 64-bit kernel with x86-based architecture. To verify the Linux kernel, run the following command:

[root@sbr-wf-eng1 ~]# cat /etc/redhat-release 
    Red Hat Enterprise Linux Server release 6.1 (Santiago)
    [root@sbr-wf-eng1 ~]# uname -a
    Linux sbr-wf-eng1 2.6.32-131.0.15.el6.x86_64 #1 SMP
        Tue May 10 15:42:40 EDT 2011 x86_64 x86_64 x86_64 GNU/Linux

You must refer to the following Signalware documentation for instructions to install and configure Signalware on a Linux platform:

  • Signalware Read Me First
  • Signalware Release Notes
  • Signalware SP Release 9 Service Pack 6 Linux Installation Manual

The Signalware documentation can be accessed from http://www.juniper.net/support/products/carrier/carrier/#doc.

To troubleshoot errors that might occur during the installation and configuration process, see Troubleshooting Signalware Installation and Configuration.

Note:

A 32-bit kernel is not supported.

The following topics are discussed in this chapter:

Modified: 2018-01-17