Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Installing an Integrated Access Service Module

    To install an Access Service Module in the Junos Pulse Gateway:

    1. Remove the blank faceplate.
    2. Pull the ejector lever outward until it is fully open.
    3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to the grounding point on the back of the device.
    4. Remove the service module from the electrostatic bag.
    5. Grasp the faceplate and align the notches in the connector at the rear of the service module with the notches in the in the Junos Pulse Gateway.
    6. Slide the service module in until it lodges firmly in the device.
    7. Close the release lever until it locks and is flush with the front of the chassis.

    Note: Service modules are paired with hard drives. When moving a service module from one slot in the chassis to another, move the corresponding hard drive from the old slot to the new slot.

    Published: 2011-07-25