Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Powering On an AC-Powered Junos Pulse Gateway

    To power on an AC-powered Junos Pulse Gateway:

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    2. Verify that the power supplies are fully inserted in the chassis.
    3. Verify that each AC power cord is securely inserted into the appliance inlet.
    4. Verify that an external management device is connected to the Junos Pulse Gateway CONSOLE port.
    5. Turn on the power to the external management device.
    6. Switch on the dedicated customer site circuit breakers for the power supplies. Follow the ESD and safety instructions for your site.
    7. Move the AC input switch on each power supply to the on (|) position and observe the status LEDs on each power supply faceplate. If an AC power supply is correctly installed and functioning normally, the AC OK and DC OK LEDs light steadily, and the PS FAIL LED is not lit.
    8. If any of the status LEDs indicates that the Junos Pulse Gateway is not functioning normally, repeat the installation and cabling procedures.

      Note: After powering off a power supply, wait at least 60 seconds before turning it back on. After powering on a power supply, wait at least 60 seconds before turning it off.

      If the system is completely powered off when you power on the power supply, the Junos Pulse Gateway boots as the power supply completes its startup sequence.

      After a power supply is powered on, it can take up to 60 seconds for status indicators—such as the status LEDs on the power supply and the show chassis command display—to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.

    9. On the external management device connected to the Junos Pulse Gateway , monitor the startup process to verify that the system has booted properly.

    Published: 2011-07-25