Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Installing an IOC in VSE1100 and VSE2100

    The VSE1100 has four ports of 1–Gigabit Ethernet traffic and VSE2100 has two ports of 10-Gigabit Ethernet traffic from fiber interface media. It is inserted horizontally into the IOC slot of the appliance.

    To install an IOC:

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to an ESD point on the appliance.

      For more information about ESD, see Prevention of Electrostatic Discharge Damage on VSE.

    2. Choose the slot where you want to insert the IOC.
    3. Loosen the captive thumbscrews that secure the blank filler panel covering the empty slot, if present, and remove the filler panel.
    4. Remove the IOC from its antistatic bag, being careful not to touch components, pins, leads, or solder connections.
    5. Verify that the ejectors are in the open position (facing outward).
    6. Guide the IOC into the chassis by placing it between the guides of the selected slot and pushing the card until it stops.

      The card stops sliding when the ejectors make contact with the appliance.

      Caution: If you meet strong resistance when attempting to seat the card using the ejectors, remove it from the appliance, and confirm that the slot is designed to hold the component. Also, be sure that you have aligned the left and right edges in the correct matching tracks.

    7. Insert the IOC into the midplane by simultaneously pressing both ejectors inward and exerting forward pressure on the card until the small red release buttons click into place.
    8. Tighten the captive thumbscrews.

    Published: 2014-04-04