Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Replacing an AC Power Supply on VSE1100 and VSE2100 Devices

    VSE1100 and VSE2100 devices are supplied with an AC power supply as standard equipment.

    Note: After powering off a power supply, wait at least 60 seconds before turning it back on.

    To remove an AC power supply:

    1. Power off the device. See Powering Off Virtual Services Engines for more information.
    2. Unplug the power cord from the power source receptacle.
    3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to an ESD point on the chassis.
    4. Unplug the power cord from the inlet in the power supply.
    5. The AC power supply has a pull handle and a locking tab. Press the locking tab to the right while you pull out the module using the handle. See Figure 1.

    Figure 1: Removing an AC Power Supply

    Removing an AC
Power Supply

    To install an AC power supply:

    1. Move the power switch next to the device inlet on the power supply to the off (0) position.
    2. Insert the new power supply module into the device. Hold the power supply locking tab to the right until the power supply is fully seated. See Figure 2.

      Figure 2: Replacing an AC Power Supply

      Replacing an AC
Power Supply
    3. Move the power supply locking tab to the left to ensure the power supply module is locked in the device.
    4. Insert the power cord into the inlet on the power supply.
    5. Insert the power cord into the AC power source outlet.
    6. Press and release the momentary rocker power switch on the rear panel of the chassis to power on the device.
    7. Observe the status LED on the power supply.

      • The LED is green when the power supply is receiving power and is powering the device.
      • The LED is amber when the power supply is receiving power but is not powering the device.

    Published: 2014-04-04