[an error occurred while processing this directive] [an error occurred while processing this directive]

Installing a JCS 1200 Switch Module Filler Tray

To install a switch module filler tray:

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Remove the switch module filler and filler tray, if one is installed (see Removing a JCS 1200 Switch Module or Module Filler and Removing a JCS 1200 Switch Module Filler Tray).
  3. Make sure that the release handle is in the open position.
  4. Slide the switch module filler tray into the switch module bay until it stops.
  5. Push the filler tray release handle to the closed position.
  6. Install a switch module or filler (see Installing a JCS 1200 Switch Module or Module Filler).
[an error occurred while processing this directive]