Technical Documentation

Replacing a JCS 1200 Media Tray

Removing a JCS 1200 Media Tray

Figure 1 shows how to remove a media tray.

Figure 1: Removing a JCS 1200 Media Tray

Image bb1cp037.gif

To remove a media tray (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Pull the media tray release handle to the open position. The media tray moves out of the bay approximately 0.25 in. (0.6 cm).
  3. Slide the media tray out of the bay.

Installing a JCS 1200 Media Tray

Figure 2 shows how to install a media tray.

Figure 2: Installing a JCS 1200 Media Tray

Image bb1de001.gif

To install a media tray (see Figure 2):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Make sure that the media tray release lever is in the open position and the compact flash release buttons are pushed into the in position.

    Figure 3: Positioning the Release Lever and Button on the JCS 1200 Media Tray

    Image bb1cp034.gif

  3. Slide the media tray into position until it stops and locks into place.
  4. Rotate the media tray release lever to the closed position.