[an error occurred while processing this directive] [an error occurred while processing this directive]

Removing a JCS 1200 Switch Module or Module Filler

Figure 1 shows how to remove and install a switch module.

Figure 1: Removing and Installing a JCS 1200 Switch Module

Image bb1cp040.gif

To remove a switch module or module filler (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Pull the release handle to the open position. The module moves out of the bay approximately 0.25 in. (0.6 cm).
  3. Slide the switch module out of the bay.
[an error occurred while processing this directive]