Replacing a JCS 1200 Network Clock Filler
Removing a JCS 1200 Network Clock Filler
Figure 1 shows how to remove and install a network clock filler.
Figure 1: Removing and Installing a JCS 1200 Network Clock Filler
To remove a network clock filler (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
- Pull the release handle to the open position. The network clock filler moves out of the bay approximately 0.25 in. (0.6 cm).
- Slide the network clock filler out of the bay.
Installing a JCS 1200 Network Clock Filler
Figure 2 shows how to remove and install a network clock filler.
Figure 2: Removing and Installing a JCS 1200 Network Clock Filler
To install a network clock filler (see Figure 2):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
- Make sure that the release handle on the network clock filler is in the open position.
- Slide the network clock filler into the module bay until it stops.
- Push the release handle to the closed position.