Technical Documentation

Installing a JCS 1200 Network Clock Filler

Figure 1 shows how to remove and install a network clock filler.

Figure 1: Removing and Installing a JCS 1200 Network Clock Filler

Image bb1cp043.gif

To install a network clock filler (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Make sure that the release handle on the network clock filler is in the open position.
  3. Slide the network clock filler into the module bay until it stops.
  4. Push the release handle to the closed position.