Replacing a JCS 1200 Media Tray
Topics include:
Removing a JCS 1200 Media Tray
Figure 1 shows how to remove a media tray.
Figure 1: Removing a JCS 1200 Media Tray
To remove a media tray (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
- Pull the media tray release handle to the open position. The media tray moves out of the bay approximately 0.25 in. (0.6 cm).
- Slide the media tray out of the bay.
Installing a JCS 1200 Media Tray
Figure 2 shows how to install a media tray.
Figure 2: Installing a JCS 1200 Media Tray
To install a media tray (see Figure 2):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
- Make sure
that the media tray release lever is in the open position and the
compact flash release buttons are pushed into the in position.
Figure 3: Positioning the Release Lever and Button on the JCS 1200 Media Tray
- Slide the media tray into position until it stops and locks into place.
- Rotate the media tray release lever to the closed position.
