Technical Documentation

Installing a JCS 1200 Bezel

Figure 1 shows how to install a bezel.

Figure 1: Installing a JCS 1200 Bezel

Image bb1da004.gif

To install a bezel (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Holding the sides of the bezel, orient the bezel so the logo is at the top and right corner.
  3. Place the bottom edge of the bezel on the bezel retention tab.
  4. Rotate the top of the bezel toward the JCS 1200 platform until the bezel clicks into place.
  5. Turn the quarter-turn bezel locks to the locked position.