[an error occurred while processing this directive] [an error occurred while processing this directive]

Replacing a JCS 1200 Fan Module

Removing a JCS 1200 Fan Module

Figure 1 shows how to remove and install a fan module.

Figure 1: Removing and Installing a JCS 1200 Fan Module

Image bb1cp080.gif

Note: While the JCS 1200 platform is operating, only one fan module should be removed at a time. Removing two fan modules might cause the JCS 1200 platform to overheat.

To remove a fan module (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Remove the shipping block that is installed below the release levers:

    Figure 2: Removing the Shipping Block

    Image bb1cp082.gif

    Note: When the JCS 1200 platform is shipped, each fan module has a shipping block installed below the release lever that is on the same side as the fan module orientation mark.

    1. Remove the Phillips-head screw that attaches the shipping block to the JCS 1200 platform.
    2. Pull the shipping block away from the JCS 1200 platform. Place the shipping block and screw in a safe place.
  3. Press down on the release levers on either side of the fan module you are removing. The module moves out of the bay approximately 0.25 in. (0.6 cm).
  4. Pull the fan module out of the bay.

Installing a JCS 1200 Fan Module

Figure 3 shows how to remove and install a fan module.

Figure 3: Removing and Installing a JCS 1200 Fan Module

Image bb1cp080.gif

To install a fan module (see Figure 3):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Orient the fan module to the selected fan module bay.

    Figure 4: Fan Module Orientation Marks

    Image bb1cp081.gif

    1. If you are installing a fan module in fan module bay 1 or 2, orient the fan so the orientation mark is at the bottom-right corner.
    2. If you are installing a fan module in fan module bay 3 or 4, orient the fan so the orientation mark is at the top-left corner.
  3. Slide the fan module into the bay until it stops.

    Note: Make sure the release levers for the fan module return to a locked position.

  4. If you are shipping the JCS 1200 platform to another location, install the shipping block that came with the JCS 1200 platform.

    Note: When the JCS 1200 platform is shipped, a shipping block must be installed for each fan module. The shipping block is installed below the release lever that is on the same side as the fan module orientation mark.

    Figure 5: Installing the JCS 1200 Shipping Block

    Image bb1cp082.gif

    1. Orient the shipping block below the release lever on the same side as the orientation mark on the fan module.
    2. Push the shipping block into the slot below the release lever.
    3. Install the Phillips-head screw that attaches the shipping block to the JCS 1200 platform.
[an error occurred while processing this directive]