[an error occurred while processing this directive] [an error occurred while processing this directive]

Removing Components from a JCS 1200 Chassis

To remove components from a JCS 1200 chassis:

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Power off any Routing Engines in the JCS 1200 platform (see Powering Off a JCS 1200 Routing Engine).
  3. Disconnect the power from the JCS 1200 platform (see Disconnecting Power from the JCS 1200 Platform).
  4. Remove the following components from the front of the JCS 1200 platform:
  5. Disengage the following components from the JCS 1200 midplane using the procedure indicated:

    Note: Make sure each component is pulled out of the JCS 1200 platform at least 1 in. (2.54 cm).

  6. Remove the fan shuttle from the JCS 1200 platform (see Removing a JCS 1200 Fan Shuttle).
  7. Remove the upper and lower power boxes from the rear of the JCS 1200 chassis (see Removing a JCS 1200 Power Box).
  8. If you are instructed to return the chassis, follow all packaging instructions and use any packaging materials for shipping that are supplied to you.
[an error occurred while processing this directive]