Technical Documentation

AC Power, Connection, and Power Cord Specifications

Detachable AC power cords are supplied with the switch. The appliance coupler at the female end of the cord inserts into the AC appliance inlet on the faceplate of the AC power supply. The coupler is type C19 as described by International Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the power cord fits into the power source outlet that is standard for your geographical location.

Note: In North America, AC power cords must not exceed 4.5 meters (approximately 14.75 feet) in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the switch are in compliance.

Table 1 lists AC power cord specifications provided for each country or region.

Table 1: AC Power Cord Specifications

Country/Region

Electrical Specifications

Plug Standards

Australia

250 VAC, 10 A, 50 Hz

AS/NZ 3112–1993

China

250 VAC, 10 A, 50 Hz

GB2099.1 1996 and GB1002 1996 (CH1-10P)

Europe (except Italy and United Kingdom)

250 VAC, 10 A, 50 Hz

CEE (7) VII

Italy

250 VAC, 10 A, 50 Hz

CEI 23–16/VII

Japan

125 VAC, 12 A, 50 Hz or 60 Hz

JIS 8303

North America

125 VAC, 10 A, 60 Hz

NEMA 5-15

United Kingdom

250 VAC, 10 A, 50 Hz

BS 1363A

Figure 1 illustrates the plug on the power cord for each country or region listed in Table 1.

Figure 1: AC Plug Types

Image g001892.gif

Caution: The AC power cord for the EX-series switch is intended for use with the switch only and not for any other use.