Configuration Commands

The reference to eth0 (LAN1 port) is for the single TCA6000 Timing Client Ethernet port and the similar configuration is used for LAN2 (eth1).

eth0 speed

—

Configures the Ethernet port to either 10 or 100 Mbps. It is recommended to use 100 Mbps (default)

eth0 duplex

—

Configures the Ethernet port as half or full duplex. For performance requirements to be achieved, full duplex (default) is required.

eth0 auto-nego

—

Configures the Ethernet port as being able to auto negotiate the speed and half/full duplex (yes / no). It is recommended this be disabled (default), that is no.

eth0 ip

—

Configures the port IP address, IP Mask and Gateway. There is only one gateway for eth0 and eth1.

config eth0 ip 192.168.50.120 255.255.255.0 192.168.50.1

eth0 ip-mode

—

Configures the IP address as being a static or dynamic.

# config eth0 ip-mode static