Status Commands

Most status commands can be executed at the 1st level of login except where noted by an asterisk (*). These commands require the 2nd level of login which is the same level as when configuration commands are executed.

ptp config:

Displays the configuration parameters of the PTP for the Default, Juniper or Telecom Profile without Signaling.

show ptp config
ptp unicast sync-int-range:

Displays the Sync event message rate for the Telecom Profile with Signaling.

ptp unicast delay-int-range:

Displays the Delay_Request/Response event message rate for the Telecom Profile with Signaling.

ptp unicast ann-int-range:

Displays the Announce interval event message rate for the Telecom Profile with Signaling.

ptp status:

Shows the PTP state parameters. This is a summary and the following individual commands provide similar information.

ptp default-dataset:

Displays the PTP parameter including Domain # that is configured.

ptp parent-dataset:

Identifies Grandmaster priority settings and other Grandmaster parameters.

ptp port-dataset:

Shows the PTP port state parameters.

ptp timescale-prop:

Displays the timing source and other timing parameters

ptp grandmaster-cluster-config:

Displays the other Grandmasters IP-Addresses which are configured for the BMC.

ptp gm dscp:

Displays the Differential Service value for the IP packets which transport the PTP event and signaling messages.

telecom-standard:

Displays the configured telecom standard based on which the PTP grandmaster announces the clock class.