CLI Configuration / Status

Configuration requires the 2nd level of login which is after login using admin / admin (or user assigned information) the config login needs to be executed which is “en” at the prompt followed by entering the password “enable”.

The network parameters of the Ethernet interface should be configured before configuring the PTP profile information.

The following parameters are set for the PTP profile through the configuration commands:

Table 36: Configuration Commands

Parameter	Value
Profile	0:Default 1:Juniper Type I 2:Telecom Profile 3:Juniper Type II
Priority 1	0 to 255
Priority 1	0 to 255
Domain Number	0 to 255
Two Step	0:no 1:yes
Delay Interval	0: 1packet/sec 1: 2packet/sec 2: 4packet/sec 3: 8packet/sec 4: 16packet/sec 5: 32packet/sec 6: 64packet/sec
Announce Interval	0: 1packet/1sec 1: 1packet/2sec 2: 1packet/4sec 3: 1packet/8sec
Sync Interval	0: 1packet/sec 1: 2packet/sec 2: 4packet/sec 3: 8packet/sec 4: 16packet/sec 5: 32packet/sec 6: 64packet/sec
Announce Receipt Timeout	2 to 10 intervals

The parameter options for the configuration command can be obtained for the configuration commands by adding a question-mark (?) after typing in # config, such as "# config ptp grandmaster ?".

Note: Configuration for Default, Brilliant/Juniper and Telecom with or without Signaling profiles can also be done through the Web Interface.