PTP Profile Types

Default Profile:

• Supports Multicast Sync, Announce, Delay response
• Supports One-Step and Two-Step modes

Juniper Type I Profile:

• Supports Default Profile (Multicast Sync, Announce and Delay response)
• Supports Multicast Sync, Announce and Unicast Delay response
• Supports One-Step and Two-step modes

Telecom Profile with and without signaling:

• Manual Configuration of Slave IP Address for Telecom profile without signaling
• Unicast Discovery features
• Total 256 Unicast Slave support
• Supports Unicast - OneStep mode only
• Signaling Support at Master and Slave
• Sends one ARP request for slave every approximately 128 seconds when unicast continuous enable case
• Sends one ARP request to gateway IP address for every 1 minute when unicast continuous enable case
• Supports Grand Master Cluster Support

  Master’s BMC between the Grand Master Cluster Table Masters

  Max Grand Master Cluster Masters allowed is 3

• Master supports signaling messages for

  Process REQUEST UNICAST TRANSMISSION for Announce

  Process REQUEST UNICAST TRANSMISSION for SYNC

  Process REQUEST UNICAST TRANSMISSION for Delay Response

  Support GRANT UNICAST TRANSMISSION for Announce

  Support GRANT UNICAST TRANSMISSION for SYNC

  Support GRANT UNICAST TRANSMISSION for Delay Response

  Support CANCEL UNICAST TRANSMISSION for Delay Response

  There is support for Dynamic Slave IP address configuration after sending Grant Message

  There is support for Dynamic delete Slave IP address after expiry of duration of Request Unicast messages

• Master supports only multiple set of configuration for Announce Rate, Sync Rate, and Delay Response Rate

  Master supports the Sync/Delay Range from 1 Pkt/Sec to 64 Pkt/Sec and Announce from 1 Pkt/sec to 1 Pkt/8Sec

Juniper Profile Type II Profile:

• Supports Default Profile
• Supports BrilliantJuniper Type I Profile
• Supports Telecom Profile (Supports OneStep mode only)