Telecom Profile – With Signaling Configuration Command

The profile requires individual parameters to be entered. Even though some parameters are not directly associated with the profile, these parameters will be shown here for consistency with the other profile configuration string.

ptp slv domain

Configures the PTP domain number to be part of the same Grandmaster(s) domain. The values can be 0 to 254 and needs to be configured as the same domain number of the associated Grandmaster(s).

# config ptp slv domain 20
ptp slv profile

Configure the profile for unicast packet types for both Sync and Delay_Request /Response PTP event messages.

# config ptp slv profile 2
ptp unicast sync

Configures the Sync message rate that the Timing Client requests from the Grandmaster.

Note: The TCA6000 Timing Client supports Sync rates of 32 or 64 pkt/sec are supported and 64 (6) is recommended.

# config ptp unicast sync 6
ptp unicast delay

Configures the Delay_Response message rate that the Timing Client requests from the Grandmaster.

Note: The TCA6000 Timing Client supports Delay_Request/Response rates of 32 or 64 pkt/sec are supported and 64 (6) is recommended.

# config ptp unicast delay 6
ptp unicast announce

Configures the Announce message rate of 1 pkt/sec to 1 pkt/8 sec that the Timing Client requests from the Grandmaster.

 # config ptp unicast announce 0
ptp unicast duration

Configures the Timing Client expire duration for sending signaling messages without receiving acknowledgement from the Grandmaster. The duration can be configured in 1 second increments from 100 to 3000.

 # config ptp unicast duration 3000
ptp unicast acc-master add

Adds the IP-address of the acceptable Grandmaster(s) for the Timing Client which is used for the Ethernet network packet IP protocol.

# config ptp unicast acc-master add 192.168.50.101
ptp unicast acc-master del

Deletes the IP-address of the acceptable Grandmaster(s) for the Timing Client which is used for the Ethernet network packet IP protocol.

# config ptp unicast acc-master del 192.168.50.101
ptp unicast signaling

Enables / Disables the signaling messages to be sent to the Grandmaster.

# config ptp unicast signaling enable

Note: When reverting back to other profiles, signaling needs to be disabled.

ptp slv dscp

Configures the Differential Service (DiffServ) of the IP packet which transports the PTP event and signaling messages. This should be configured to Explicit Forward (EF) which is a value of 46 decimal.

# config ptp slv dscp 46