Default Profile Configuration Command

The profile is configured with other PTP parameters within a configuration string. The Sync and Delay_Response rates at the Grandmaster are required to match the Timing Client Sync and Delay_Request packet rates.

ptp slave:

The parameters that are required to be configured are the PTP Domain # (0-254), the Sync / Delay_Request packet type as being multicast, the profile type as not being Telecom Profile, the Delay_Request packet rate and the Announce message type response from the Grandmaster timeout interval.

ptp slv

[domain #=20] [Default Profile = 1 0 (multicast) & (Telecom Profile disabled)] [Delay Req Interval = 6] [Announce Receipt Timeout=10]

Note: Only Delay Req Interval rates of 32 or 64 pkt/sec are supported and 64 (6) is recommended.

# config ptp slave 20 1 1 6 10
ptp slv dscp

Configures the Differential Service (DiffServ) of the IP packet which transports the PTP event and signaling messages. This should be configured to Explicit Forward (EF) which is a value of 46 decimal.

# config ptp slv dscp 46
config ptp slv disable

Disables the PTP protocol. Only after your confirmation, the PTP protocol is disabled.

Note: This command is applicable for all profile types.

# config ptp slv disable
Are you sure you want to disable slave ptp? y/n
y
config ptp slv enable

Enables the PTP protocol. Only after your confirmation, the PTP protocol is enabled.

Note: This command is applicable for all profile types.

# config ptp slv enable
Are you sure you want to enable slave ptp? y/n
y