ON THIS PAGE
Alarm Relay Contact Wire Specifications for the SRX5600 Services Gateway
Console Port Cable and Wire Specifications for the SRX5600 Services Gateway
RJ-45 Connector Pinouts for the SRX5600 Services Gateway Routing Engine Ethernet Port
RJ-45 Connector Pinouts for the SRX5600 Services Gateway Routing Engine Auxiliary and Console Ports
SRX5600 Alarm and Management Cable Specifications and Pinouts
Alarm Relay Contact Wire Specifications for the SRX5600 Services Gateway
Table 1 lists the specifications for the wires that connect to the alarm relay contacts.
Table 1: Cable and Wire Specifications for Alarm Interfaces
Port | Cable Specification | Cable/Wire Supplied |
---|---|---|
Alarm relay contacts | Wire with gauge between 28-AWG and 14-AWG (0.08 and 2.08 mm2) | No |
Console Port Cable and Wire Specifications for the SRX5600 Services Gateway
Table 2 lists the specifications
for the cable that connects a CONSOLE
port on
the Routing Engine to a management console.
Table 2: Cable and Wire Specifications for Routing Engine Management and Alarm Interfaces
Port | Cable Specification | Cable/Wire Supplied | Maximum Length | Receptacle |
---|---|---|---|---|
Routing Engine console or auxiliary interface | RS-232 (EIA-232) serial cable | One 6-ft (1.83-m) length with RJ-45/DB-9 connectors | 6 ft (1.83 m) | RJ-45/DB-9 plug |
RJ-45 Connector Pinouts for the SRX5600 Services Gateway Routing Engine Ethernet Port
The port on the Routing Engine labeled ETHERNET
is an autosensing 10/100-Mbps Ethernet RJ-45 receptacle that accepts
an Ethernet cable for connecting the Routing Engine to a management
LAN (or other device that supports out-of-band management). Table 3 describes the RJ-45 connector
pinout.
Table 3: RJ-45 Connector Pinout for the Routing Engine ETHERNET Port
Pin | Signal |
---|---|
1 | TX+ |
2 | TX- |
3 | RX+ |
4 | Termination network |
5 | Termination network |
6 | RX- |
7 | Termination network |
8 | Termination network |
RJ-45 Connector Pinouts for the SRX5600 Services Gateway Routing Engine Auxiliary and Console Ports
The ports on the Routing Engine labeled AUX
and CONSOLE
are asynchronous serial interfaces
that accept an RJ-45 connector. The ports connect the Routing Engine
to an auxiliary or console management device. Table 4 describes the RJ-45 connector pinout.
Table 4: RJ-45 Connector Pinout for the AUX and CONSOLE Ports
Pin | Signal | Description |
---|---|---|
1 | RTS | Request to Send |
2 | DTR | Data Terminal Ready |
3 | TXD | Transmit Data |
4 | Ground | Signal Ground |
5 | Ground | Signal Ground |
6 | RXD | Receive Data |
7 | DSR/DCD | Data Set Ready |
8 | CTS | Clear to Send |