QFX5130-32CD Installation Overview
Overview of Installing the QFX5130-32CD
You can mount a QFX5130-32CD:
Flush with the front of a 19-in. four-post rack. Use the standard mounting brackets provided with the switch for this configuration.
Recessed 2 in. (5 cm) from the front of a 19-in. four-post rack. Use the extension bracket provided in the standard mounting kit for this configuration. Recessed mounting is primarily used in enclosed cabinets to allow room for cabling.
To install and connect a QFX5130-32CD:
- Follow the instructions in Unpack a QFX5130-32CD .
- Determine how the switch is to be mounted.
Flush or recessed mounted in a rack or cabinet, see Mounting a qfx5130-32CD in a Rack or Cabinet.
- Follow the instructions in:
- Follow the instructions in Performing the Initial Software Configuration for QFX5130-32CD Switches.
QFX5130 Installation Safety Guidelines
The weight of a fully loaded QFX5130 chassis is approximately 24.5 lb (11.11 kg) with power supplies and fans installed.Observe the following guidelines for lifting and moving a QFX5130:
If you are installing the QFX5130 above 60 in. (152.4 cm) from the floor, either remove the power supplies, fan modules, and any expansion modules before attempting to install the switch, or ask someone to assist you during the installation.
Before installing a QFX5130, read the guidelines in QFX5130-32CD Site Preparation Checklist to verify that the intended site meets the specified power, environmental, and clearance requirements.
Before lifting or moving the QFX5130, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your back. Keep your knees bent and your back relatively straight and avoid twisting your body as you lift. Balance the load evenly and be sure that your footing is solid.