Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

MX10016 Alarm and Management Cable Specifications and Pinouts

 

Console Port Connector Pinouts for an MX10016 Router

The console port (labeled CON) on the RCB panel is an RS-232 serial interface that uses an RJ-45 connector to connect to a console management device. The default baud rate for the console port is 9600 baud.

Table 1 provides the pinout information for the RJ-45 console connector. An RJ-45 cable and RJ-45 to DB-9 adapter are supplied with the MX10016.

Note

If your laptop or PC does not have a DB-9 plug connector pin and you want to connect your laptop or PC directly to an MX10016 router, use a combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the device and a USB to DB-9 plug adapter. You must provide the USB to DB-9 plug adapter.

Table 1: Console Port Connector Pinouts for an MX10016

Pin

Signal

Description

1

RTS output

Request to send

2

DTR output

TOD output for PTP applications

Data terminal ready

Time of day for Precision Time Protocol (PTP). You can use DTR pins as a TOD universal asynchronous receiver/transmitter (UART) by using breakout cables.

3

TxD output

Transmit data

4

Signal oround

Signal ground

5

Signal oround

Signal ground

6

RxD input

Receive data

7

DCD input

TOD iutput for PTP applications

Data carrier detect

Time of day for PTP. You can use DCD pins as a TOD UART by using breakout cables.

8

CTS input

Clear to send

USB Port Specifications for an MX10016

The following Juniper Networks USB flash drives have been tested and are officially supported for the USB port in the MX10016 router:

  • RE-USB-1G-S—1-gigabyte (GB) USB flash drive

  • RE-USB-2G-S—2-GB USB flash drive

  • RE-USB-4G-S—4-GB USB flash drive

Caution

Any USB memory product not listed as supported for the MX10016 router has not been tested by Juniper Networks. The use of any unsupported USB memory product could expose your device to unpredictable behavior. Juniper Networks Technical Assistance Center (JTAC) can provide only limited support for issues related to unsupported hardware. We strongly recommend that you use only supported USB flash drives.

Caution

Remove the USB flash drive before upgrading Junos OS or rebooting an MX10016 router. Failure to do so could expose your device to unpredictable behavior.

Note

USB flash drives used with the MX10016 router must support USB 2.0 or later.

Management Port Connector Pinouts for an MX10016

The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect either to the control plane and management network in an MX10016 router, or to a management device for out-of-band management.

Table 2 provides the pinout information of the RJ-45 management port connector. An RJ-45 cable is supplied with the MX10016 router.

Table 2: RJ-45 Management Port Connector Pinouts for an MX10016

Pin

Signal

Description

1

TRP1+

Transmit/receive data pair 1

2

TRP1–

Transmit/receive data pair 1

3

TRP2+

Transmit/receive data pair 2

4

TRP3+

Transmit/receive data pair 3

5

TRP3–

Transmit/receive data pair 3

6

TRP2–

Transmit/receive data pair 2

7

TRP4+

Transmit/receive data pair 4

8

TRP4–

Transmit/receive data pair 4