Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

JRR200 Network Cable and Transceiver Planning

 

Pluggable Transceivers Supported on JRR200 Route Reflector

The ports on the JRR200 Route Reflector supports SFP+ transceivers. You can find the list of transceivers supported on JRR200 route reflector and information about those transceivers at the The Hardware Compatibility Tool.

Note

We recommend that you use only optical transceivers and optical connectors purchased from Juniper Networks with your Juniper Networks device.

Caution

If you face a problem running a Juniper Networks device that uses a third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help you diagnose the source of the problem. Your JTAC engineer might recommend that you check the third-party optic or cable and potentially replace it with an equivalent Juniper Networks optic or cable that is qualified for the device.

SFP+ Direct Attach Copper Cables for JRR200 Route Reflector

Small form-factor pluggable plus transceiver (SFP+) direct attach copper (DAC) cables are suitable for short distances of up to 23 ft (7 m), making them ideal for highly cost-effective networking connectivity within a rack and between adjacent racks. The JRR200 Route Reflector supports the following 1 m and 3 m long DAC cables:

  • SRX-SFP-10GE-DAC-1M

  • SRX-SFP-10GE-DAC-3M

For the full specifications of these transceivers, see The Hardware Compatibility Tool.