Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

ON THIS PAGE

Expansion Module for the PTX10001

 

The PTX10001 has one bay on the port panel for an optional expansion module. For instructions on replacing an expansion module, see Maintaining a PTX10001 Expansion Module.

The PTX10001 supports the JNP10001-16C-PIC expansion module.

JNP10001-16C-PIC

The JNP10001-16C-PIC expansion module provides 16 additional QSFP28 ports. The QSFP28 ports support 10-Gbps, 40-Gbps, and 100-Gbps port speeds.

Figure 1 shows the JNP10001-16C-PIC ports and LEDs.

Figure 1: JNP10001-16C-PIC Faceplate and LEDs
JNP10001-16C-PIC Faceplate
and LEDs
  1
Lane LEDs (L0 to L3)
  4
Offline button (OFFLINE)
  2
Network port LEDs (0 to 15)
  5
QSFP28 network ports
  3
Expansion module status LEDs (OK/Fail)
 

The JNP10001-16C-PIC network ports support:

  • 100 Gbps QSFP28 transceivers

  • 40 Gbps QSFP+ transceivers

  • 100 Gbps active optical cables (AOC)

  • 40 Gbps AOC

  • QSFP28 direct attach copper (DAC) cables

  • QSFP+ DAC cables

  • QSFP+ direct attach copper break out (DACBO) cables

  • QSFP28 DACBO cables

Description

  • Weight: 3.2 lb (1.45 kg)

  • Power requirement: 200 W

  • Name in the CLI: 16xQSFP28 Macsec TIC

Hardware features

  • Sixteen 100-Gigabit Ethernet ports that support quad small form-factor pluggable (QSFP28) transceivers

  • The ports are numbered 0 through 15.

  • Each port can be configured as a 100-Gigabit Ethernet port, 40-Gigabit Ethernet port, or as four 10-Gigabit Ethernet ports (by using a breakout cable).

Software features

  • Supports rate selectability at the port level.

  • By default, the ports are configured as 100-Gigabit Ethernet ports.

  • Supports remote port identification.

  • Supports Media Access Control Security (MACsec)

Cables and connectors

Tip: You can use the Hardware Compatibility Tool to find information about the pluggable transceivers supported on your Juniper Networks device.

LEDs

  • OK/FAIL LED, one bicolor:

    • OFF—The expansion module is offline.

    • Green—The expansion module is online.

    • Red—The expansion module is in a power failure state.

  • Port LED:

    • Off—Link is not plugged in.

    • Green—Link is up.

    • Amber—Link is down due to loss of signal or it is configured down.

    • Red—Link is down.

  • Lane LEDs:

    • Off—No demand for diagnosis or the lane number does not apply to the selected port.

    • Green—Lane is up.

    • Amber—Link is down due to loss of signal or it is configured down.

    • Red—Link is down.