Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Maintaining the EX9214 Cable Management Bracket

 

Removing the Cable Management Bracket from an EX9214 Switch

The cable management bracket is installed below the line card and SF module slots on the front panel.

Before you remove a cable management bracket from the switch:

Ensure that you have the following parts and tools available:

  • ESD grounding strap

  • 7/16 in. (11 mm) nut driver

To remove the cable management bracket:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Unscrew the nuts on the corners of the cable management bracket by using the 7/16 in. (11 mm) nut driver. See Figure 1.
    Figure 1: Removing the Cable Management Bracket
    Removing the Cable
Management Bracket
  3. Grasp the bottom of the cable management bracket and pull it straight out from the studs on the chassis.

Installing the Cable Management Bracket in an EX9214 Switch

You can install the cable management bracket below the line card and SF module slots on the front panel.

Before you install a cable management bracket in the switch:

Ensure that you have the following parts and tools available:

  • ESD grounding strap

  • 7/16 in. (11 mm) nut driver

To install the cable management bracket:

  1. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD point on the chassis.
  2. Position the cable management bracket on the studs on the lower part of the front panel. See Figure 2.
  3. Insert the nuts on the corners in the cable management bracket into the studs on the chassis.
  4. Tighten the captive screws using a 7/16 in. (11 mm) nut driver.
Figure 2: Installing the Cable Management Bracket in an EX9214 Switch
Installing the
Cable Management Bracket in an EX9214 Switch