Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Maintaining the EX9208 Cable Management Brackets

 

Installing Cable Management Brackets on an EX9208 Switch

Before you install cable management brackets on the switch:

Ensure that you have the following parts and tools available to install cable management brackets on an EX9208 switch chassis:

  • ESD grounding strap

  • Phillips (+) screwdriver, number 1 and 2

The cable management brackets attach to both sides of the switch. To install the cable management brackets (see Figure 1):

  1. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
  2. Position the cable management brackets on the front sides of the chassis.
  3. Insert the tabs into the slots.
  4. Tighten the captive screws completely.
Figure 1: Installing the Cable Management Brackets in an EX9208 Switch
Installing the Cable
Management Brackets in an EX9208 Switch

Removing Cable Management Brackets from an EX9208 Switch

Ensure that you have the following parts and tools available to remove the cable management brackets from an EX9208 switch chassis:

  • Electrostatic discharge (ESD) grounding strap

  • Phillips (+) screwdriver, number 1 and 2

To remove the cable management brackets:

  1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Loosen the captive screws on either side of the chassis by using the screw driver.
  3. Remove the cable management brackets.