Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Perform a Swap Test on the SSB

    Purpose

    To verify SSB failure by performing a swap test on the SSB.

    Caution: Before performing a swap test, always check for bent pins in the midplane and check the SCB for stuck pins in the connector. Pins stuck in the component connector can damage other good slots during a swap test.

    Action

    To perform a swap test on the SSB:

    1. Attach an electrostatic discharge (ESD) strap to your bare wrist, and connect the strap to one of the two ESD points on the chassis.
    2. Locate the SSB offline switch on the front panel and press and hold the switch for 5 seconds to take the SSB offline.

      Caution: If you take the SSB offline, packet forwarding will be affected.

    3. Unscrew the thumbscrews on the left and right sides of the card carrier to unseat the SSB from the midplane.
    4. Flip the ends of the two extractor clips, which are adjacent to the thumbscrews, towards the outside edges of the router.
    5. Grasp both sides of the card carrier and slide the SSB about three-quarters of the way out of the router.
    6. Move one of your hands underneath the SSB to support it, and slide it completely out of the chassis.
    7. Replace the SSB with one that you know works.
    8. Grasp the front of the SSB card carrier with both hands and align the back of the card carrier with the slide guides on the chassis.
    9. Slide the SSB card carrier all the way into the card cage until it contacts the midplane.
    10. Flip the extractor clips, located on the left and right sides of the card carrier, towards each other to secure the SSB in place.
    11. Tighten the thumbscrews on the left and right sides of the card carrier to seat the SSB.

      Note: To seat the SSB properly, be sure to tighten the screws adequately. If the SSB is not seated properly, it will not function.

    12. Verify that the SSB works by using the show chassis ssb command. (See Display the Redundant SSB Detailed Status.)

    Published: 2012-08-20